The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store a DTC immediately.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0606 | ECM / PCM Processor | Either condition is met (1 trip detection logic):
·
There is an ECM main CPU error. ·
There is an ECM sub CPU error. |
ECM | Comes on | DTC stored |
| Required sensors/Components | ECM |
| Frequency of Operation | Continuous |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON and wait for 10 seconds or more.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Clear the DTCs.
Turn the intelligent tester off.
Turn the ignition switch off.
Disconnect the intelligent tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Wait 1 second or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check for DTCs.
P0606 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG