Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › SFI SYSTEM(w/o Secondary Air Injection System) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009569 2TR-FE ENGINE CONTROL _0052091 SFI SYSTEM(w/o Secondary Air Injection System) C

2TR-FE ENGINE CONTROL  SFI SYSTEM(w/o Secondary Air Injection System)  P0607  Control Module Performance  


DESCRIPTION

·

The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is stored.

·

The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store a DTC immediately.


DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0607 Control Module Performance A CPU reset is performed after one of the following conditions is met (1 trip detection logic):
·

There is an ECM main CPU error.

·

There is an ECM sub CPU error.

·

There is an electronic throttle monitoring CPU error.


ECM Comes on DTC stored

MONITOR STRATEGY

Required sensors/Components ECM
Frequency of operation Continuous: ECM / PCM processor
Once per driving cycle: Internal control module monitoring processor performance

CONFIRMATION DRIVING PATTERN

1.

Turn the ignition switch off.

2.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

3.

Connect the cable to the negative (-) battery terminal.

4.

Turn the ignition switch to ON and wait for 16 seconds or more.


PROCEDURE

1.CHECK FOR DTC
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

e.

Turn the intelligent tester off.


f.

Turn the ignition switch off.


g.

Disconnect the intelligent tester.


h.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.


i.

Connect the cable to the negative (-) battery terminal.


j.

Connect the intelligent tester to the DLC3.


k.

Turn the ignition switch to ON and turn the intelligent tester on.


l.

Wait 16 seconds or more.


m.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine > Trouble Codes
50001 61

n.

Check for DTCs.

OK:

P0607 is not output.



Result:
Proceed to
OK
NG



OK

NG