Refer to DTC P0180 (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>P0180).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0168 | Fuel Temperature Too High | All of following conditions are met (1 trip detection logic):
·
The engine speed is more than 3200 rpm. ·
The vehicle speed is more than 10 km/h (6.25 mph). ·
The fuel temperature is 120°C (248°F) or higher for the specified time. |
·
Fuel cooler (Problem cooling fuel) ·
Fuel lines or fuel filter clogged |
Comes on | DTC stored |
| DTC Detection Drive Pattern | Drive vehicle at high speed or with heavy load (Use freeze frame data from time malfunction occurred as reference while driving) |
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
|---|---|
| P0168 is output | A |
| P0168 and other DTCs are output | B |
If DTCs other than P0168 are output, perform troubleshooting for those codes first.
A
B
Perform a visual inspection of the exterior of the fuel supply pump assembly and check that there are no fuel leaks.
There are no fuel leaks or stains.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if dirt is clogging the fuel cooler cooling fins. Clean the fins if they are clogged with dirt.
If the fuel cooler cooling fins are not clogged with dirt, replace the fuel filter.
| Proceed to |
|---|
| NEXT |
NEXT
Replace the fuel supply pump assembly.
Click hereEngine / Hybrid System>1KD-FTV FUEL>FUEL SUPPLY PUMP(w/o Glow Plug Controller)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Bleed the air from the fuel system.
Click hereEngine / Hybrid System>1KD-FTV FUEL>FUEL SYSTEM(w/o Glow Plug Controller)>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT
Perform fuel supply pump initialization.
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Connect the intelligent tester to the DLC3.
Clear the DTCs.
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>DTC CHECK / CLEAR
Turn the ignition switch to ON and turn the tester on.
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Data List / Fuel Temperature.
| Tester Display |
|---|
| Fuel Temperature |
Drive the vehicle in a city area and check that the value of Fuel Temperature does not exceed 110°C (230°F).
| Proceed to |
|---|
| NEXT |
NEXT