Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM(for Radio and Display Type) › 2012.10–2013.10
RM1840EF _56 Audio / Visual / Telematics _009633 PARK ASSIST / MONITORING _0052662 REAR VIEW MONITOR SYSTEM(for Radio and Display Type) J

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM(for Radio and Display Type)  Display Signal Circuit between Radio and Display Assembly and Television Camera Assembly  


DESCRIPTION

The display signal from the rear television camera assembly transmits to the radio and display receiver assembly.

WIRING DIAGRAM

E224825
0.219,2.813 0.583,2.958 0.365,0.146 10 false M2 0.219,2.958 1.75,3.427 1.531,0.469 10 false Rear Television Camera Assembly 5.625,2.802 6.083,2.948 0.458,0.146 10 false G2 5.76,2.385 6.198,2.531 0.438,0.146 10 false CGND 5.76,1.958 6.198,2.104 0.438,0.146 10 false V+ 5.76,1.469 6.198,1.615 0.438,0.146 10 false V- 5.74,0.99 6.177,1.135 0.438,0.146 10 false CA+ 1.01,2.385 1.448,2.531 0.438,0.146 10 false CGND 1.135,1.958 1.448,2.104 0.313,0.146 10 false CV+ 1.156,1.458 1.448,1.604 0.292,0.146 10 false CV- 1.146,1 1.448,1.146 0.302,0.146 10 false CB+ 1.542,2.24 1.75,2.385 0.208,0.146 10 false 3 1.542,1.813 1.688,1.958 0.146,0.146 10 false 2 1.542,1.323 1.688,1.469 0.146,0.146 10 false 1 1.542,0.854 1.688,1 0.146,0.146 10 false 4 5.469,2.24 5.656,2.385 0.188,0.146 10 false 15 5.542,1.813 5.656,1.958 0.115,0.146 10 false 8 5.469,1.323 5.646,1.469 0.177,0.146 10 false 16 5.552,0.854 5.667,1 0.115,0.146 10 false 7 4.573,2.469 5.146,2.615 0.573,0.146 10 false Shielded 3.74,2.469 4.313,2.615 0.573,0.146 10 false Shielded 2.052,2.479 2.625,2.625 0.573,0.146 10 false Shielded 2.896,2.469 3.469,2.615 0.573,0.146 10 false Shielded 5.604,2.948 6.813,3.406 1.208,0.458 10 false Radio and Display Receiver Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the G2 radio and display receiver assembly connector.


b.

Disconnect the M2 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G2-7 (CA+) - M2-4 (CB+) Always Below 1 Ω
G2-8 (V+) - M2-2 (CV+) Always Below 1 Ω
G2-15 (CGND) - M2-3 (CGND) Always Below 1 Ω
G2-16 (V-) - M2-1 (CV-) Always Below 1 Ω
G2-7 (CA+) - Body ground Always 10 kΩ or higher
G2-8 (V+) - Body ground Always 10 kΩ or higher
G2-15 (CGND) - Body ground Always 10 kΩ or higher
G2-16 (V-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
a.
E224536
1.49,0.146 1.875,0.438 0.385,0.292 0.615,1.406 0.792,1.406 0.792,1.406 1.063,1.281 true 0.844,1.771 1.063,1.771 1.063,1.771 1.271,1.292 true 1.583,0.219 1.813,0.375 0.229,0.156 10 G2 0.083,0.042 0.375,0.271 0.292,0.229 10 *a 0.417,1.313 0.604,1.479 0.188,0.167 10 V- 0.417,1.688 0.875,1.854 0.458,0.167 10 CGND
*a Component without harness connected
(Radio and Display Receiver Assembly)


Disconnect the G2 radio and display receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G2-16 (V-) - Body ground Always Below 1 Ω
G2-15 (CGND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
a.
E227664
1.5,0.25 1.927,0.521 0.427,0.271 1.823,1.448 2.281,1.75 2.281,1.75 2.479,1.75 true 1.552,1.448 1.125,1.74 1.125,1.74 0.938,1.74 true 1.625,0.302 1.854,0.469 0.229,0.167 10 M2 0.073,0.042 0.302,0.208 0.229,0.167 10 *a 2.552,1.667 2.865,1.833 0.313,0.167 10 CB+ 0.479,1.667 0.917,1.833 0.438,0.167 10 CGND
*a Front view of wire harness connector
(to Rear Television Camera Assembly)


Disconnect the M2 rear television camera assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
M2-4 (CB+) - M2-3 (CGND) Ignition switch ON, shift lever in R 5.5 to 7.05 V



Result:
Proceed to
OK
NG



OK

4.CHECK REAR TELEVISION CAMERA ASSEMBLY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

4.CHECK REAR TELEVISION CAMERA ASSEMBLY
a.

Using an oscilloscope, check the waveform.

E224537
0.896,0.604 1.229,0.844 0.333,0.24 0.604,1.271 0.427,1.063 0.427,1.063 0.323,1.063 true 0.604,1.521 0.427,1.865 0.427,1.865 0.323,1.865 true 2.729,1.813 2.552,2.302 2.552,2.302 2.438,2.302 true 2.833,1.708 3.042,2.302 3.042,2.302 3.146,2.302 true 5.427,1.656 5.25,2.292 5.25,2.292 5.146,2.292 true 5.552,1.583 5.75,2.292 5.75,2.292 5.865,2.292 true 0.969,0.646 1.198,0.802 0.229,0.156 10 G2 0.115,0.188 0.406,0.417 0.292,0.229 10 *a 2.125,0.448 2.417,0.677 0.292,0.229 10 *b 3.167,2.208 3.354,2.375 0.188,0.167 10 *e 2.281,2.219 2.469,2.375 0.188,0.156 10 *d 1.99,1.26 2.365,1.49 0.375,0.229 10 GND 0.135,0.979 0.344,1.146 0.208,0.167 10 V+ 0.156,1.781 0.333,1.938 0.177,0.156 10 V- 4.656,1.26 5.031,1.49 0.375,0.229 10 GND 4.865,0.448 5.156,0.677 0.292,0.229 10 *c 5.885,2.208 6.073,2.375 0.188,0.167 10 *e 4.979,2.208 5.167,2.365 0.188,0.156 10 *d
*a Component with harness connected
(Radio and Display Receiver Assembly)
*b Waveform 1
*c Waveform 2 *d Synchronized Signal
*e Video Waveform - -


HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.


Measurement Condition
Item Content
Terminal No. (Symbol) G2-8 (V+) - G2-16 (V-)
Tool Setting 0.2 V/DIV., 50 μs/DIV.
Condition Waveform 1: Ignition switch ON, shift lever in R
Waveform 2: Ignition switch ON, shift lever in R, screen blacked out by covering camera lens

OK:

Waveform is as shown in the illustration.


HINT:

The video waveform changes according to the image sent by the rear television camera assembly.



Result:
Proceed to
OK
NG



OK

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY