This is the display signal circuit between the navigation receiver assembly and the rear television camera assembly.
Disconnect the G153 navigation receiver assembly connector.
Disconnect the M2 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G153-7 (CA+) - M2-4 (CB+) | Always | Below 1 Ω |
| G153-8 (V+) - M2-2 (CV+) | Always | Below 1 Ω |
| G153-15 (CGND) - M2-3 (CGND) | Always | Below 1 Ω |
| G153-16 (V-) - M2-1 (CV-) | Always | Below 1 Ω |
| G153-7 (CA+) - Body ground | Always | 10 kΩ or higher |
| G153-8 (V+) - Body ground | Always | 10 kΩ or higher |
| G153-15 (CGND) - Body ground | Always | 10 kΩ or higher |
| G153-16 (V-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Navigation Receiver Assembly) |
Disconnect the G153 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G153-15 (CGND) - Body ground | Always | Below 1 Ω |
| G153-16 (V-) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Rear Television Camera Assembly) |
Disconnect the M2 rear television camera assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M2-4 (CB+) - M4-3 (CGND) | Ignition switch ON, shift lever in R | 5.5 to 7.05 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the rear television camera assembly with a new or normally functioning one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA>REMOVAL
| Proceed to |
|---|
| OK |
| NG |
OK
NG