This DTC is stored when a malfunction occurs in a panel switch.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B158B | Touch Switch Malfunction | Touch switch malfunction | Navigation receiver assembly |
Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
No foreign matter is caught between the display and exterior frame of the multi-display.
If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check for foreign matter on the display.
The display is clean.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for the DTCs and check if the same trouble occurs again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG