Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2012.04–2012.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052661 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Noise Occurs  


PROCEDURE

1.NOISE CONDITIONS
a.

Check from which direction the noise comes.

·

Front No. 1 speaker assembly LH

·

Front No. 1 speaker assembly RH

·

Front No. 2 speaker assembly LH

·

Front No. 2 speaker assembly RH

·

Rear speaker assembly LH

·

Rear speaker assembly RH


OK:

The location of the noise source can be determined.



Result:
Proceed to
OK
NG



OK

2.CHECK SPEAKERS

NG

3.CHECK NOISE CONDITIONS
2.CHECK SPEAKERS
a.

Check the installation conditions of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other malfunctions.

Result:
Result Proceed to
No malfunction is found A
A speaker is installed incorrectly B
Foreign objects are in the speaker C
A speaker cone is broken D




A

3.CHECK NOISE CONDITIONS

B

REINSTALL SPEAKER

C

REMOVE FOREIGN OBJECT

D

REPLACE SPEAKER

3.CHECK NOISE CONDITIONS
a.

Check the noise condition.

HINT:

The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.


Condition Under Which Noise Occurs Noise Source
Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped. Generator
Noise occurs during A/C or heater operation. Blower motor
Noise occurs when the horn switch is pressed and released or when pressed and held. Horn
Noise occurs synchronously with the blink of the turn signal. Flasher
Noise occurs during window washer operation. Washer
Noise occurs during wiper operation. Wiper
Noise occurs when the brake pedal is depressed. Stop light switch
Others Static electricity

HINT:
·

In the left column of the chart, find the situation that matches the customer complaint. Then, in the right column, find the part that is causing the noise. Check the noise filter on or for the part.

·

To save time and avoid a misdiagnosis, first make sure that the noise is not coming from outside the vehicle.

·

Noise should be removed in descending order of loudness.

·

Setting the radio to a frequency where no signal is received may make recognition of the noise problem easier.



OK:

The noise source cannot be determined.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE NOISE SOURCE