Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2012.10–2013.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052661 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Parking Brake Switch Circuit  


DESCRIPTION

This circuit includes the parking brake switch and navigation receiver assembly.

WIRING DIAGRAM

C240177
5.292,2.802 6.531,3.198 1.24,0.396 10 false Navigation Receiver Assembly 2.969,2.188 4.302,2.573 1.333,0.385 10 false Parking Brake Switch Assembly 2.979,2.01 3.229,2.167 0.25,0.156 10 false K6 5.292,2.635 5.719,2.792 0.427,0.156 10 false G153 5.313,1.521 5.448,1.677 0.135,0.156 10 false 6 3.969,1.531 4.104,1.688 0.135,0.156 10 false 1 5.573,1.646 5.927,1.802 0.354,0.156 10 false PKB

PROCEDURE

1.CHECK PARKING BRAKE SWITCH ASSEMBLY

b.

Check that the display changes between On and Off according to the parking brake operation.

OK:
Parking Brake Condition Display
Applied On
Released Off


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
a.

Disconnect the G153 navigation receiver assembly connector.


b.

Disconnect the K6 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G153-6 (PKB) - K6-1 Always Below 1 Ω
G153-6 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.
C217121
1.927,1.49 2.219,1.49 false
V100135

On
V100136

Off


Remove the parking brake switch assembly.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
Switch connector terminal - Switch body On (Shaft not pressed) Below 1 Ω
Off (Shaft pressed) 10 kΩ or higher


If the result is not as specified, replace the parking brake switch assembly.


Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY