Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009608 CRUISE CONTROL _0052446 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0500  Vehicle Speed Sensor Circuit Malfunction  P0503  Vehicle Speed Sensor Circuit Malfunction  


DESCRIPTION

The cruise control system uses the same vehicle speed signal that is sent to the ECM for the ECD system. If DTC P0500 or P0503 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the ECD system. The speed signal is converted for use by the cruise control inside the ECM. Both the ECD system and the cruise control system can set DTC P0500, however, the detection conditions of the two systems are different.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0500 Vehicle Speed Sensor Circuit Malfunction No vehicle speed sensor signal to ECM under conditions (a) and (b) (2 trip detection logic):
(a) Cruise control system is operating
(b) Vehicle is being driven
·

Vehicle speed sensor circuit

·

Vehicle speed sensor

·

Combination meter assembly

·

ECM


P0503 Vehicle Speed Sensor Circuit Malfunction No vehicle speed sensor signal to ECM under conditions (a) and (b) (2 trip detection logic):
(a) Cruise control system is operating
(b) Vehicle is being driven
·

Vehicle speed sensor circuit

·

Vehicle speed sensor

·

Combination meter assembly

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

This DTC may be stored under the ECD system at the same time. In that case, perform troubleshooting for the ECD system first.


PROCEDURE

1.CHECK COMBINATION METER SYSTEM
a.

Inspect the circuits that send vehicle speed signals to this system in the meter system.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>Speed Signal Circuit

HINT:

During inspection for the meter section, if there is an instruction that indicates to proceed to the next suspected area, proceed to the next step.



Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).


ii.

Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more.


iii.

Turn the cruise control main switch on.


iv.

Push the cruise control main switch to -SET to activate cruise control.



c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

OK:

DTC P0500 or P0503 output does not occur.


Result:
Result Proceed to
OK A
NG (w/ EGR cooler) B
NG (w/o EGR cooler) C




A

B

C