Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) › 2012.04–2012.10
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052656 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:

Use these procedures to troubleshoot the audio and visual system.


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.



Result:
Proceed to
NEXT



NEXT

3.BASIC INSPECTION
3.BASIC INSPECTION
a.

Turn the ignition switch to ON.


b.

Check whether or not the radio receiver turns on.

Result:
Result Proceed to
Radio receiver turns on A
Radio receiver does not turn on B




A

4.CHECK FOR DTC

B

6.OVERALL ANALYSIS AND TROUBLESHOOTING
4.CHECK FOR DTC

b.

Clear the DTCs.


c.

Recheck for DTCs by simulating the operation indicated by the DTCs.

Result:
Result Proceed to
DTC is not output A
DTC is output B




A

5.PROBLEM SYMPTOMS TABLE

B

5.PROBLEM SYMPTOMS TABLE
a.

Refer to the Problem Symptoms Table.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B




A

6.OVERALL ANALYSIS AND TROUBLESHOOTING

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END