Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) › 2012.01–2012.04
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052656 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends an external device sound signal to the radio receiver assembly through this circuit.

The sound signal that has been sent is amplified by the radio receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.

WIRING DIAGRAM

C240216
1.677,2.958 1.885,3.115 0.208,0.156 10 false 9 1.677,2.458 1.885,2.615 0.208,0.156 10 false 7 1.677,1.938 1.885,2.094 0.208,0.156 10 false 5 1.677,1.438 1.885,1.594 0.208,0.156 10 false 6 1.677,3.479 1.885,3.635 0.208,0.156 10 false 8 1.677,4.594 1.885,4.75 0.208,0.156 10 false 3 1.677,4.094 1.885,4.25 0.208,0.156 10 false 2 5.333,2.865 5.542,3.021 0.208,0.156 10 false 11 1.146,3.052 1.573,3.208 0.427,0.156 10 false AGND 1.146,2.542 1.573,2.698 0.427,0.156 10 false ASGN 1.25,2.021 1.583,2.177 0.333,0.156 10 false ARO 1.271,1.51 1.583,1.667 0.313,0.156 10 false ALO 1.156,3.552 1.583,3.708 0.427,0.156 10 false AUXO 5.688,3.052 6.167,3.313 0.479,0.26 10 false AGND 5.344,2.344 5.552,2.5 0.208,0.156 10 false 27 5.688,2.542 6.167,2.792 0.479,0.25 10 false VA- 5.333,1.844 5.542,2 0.208,0.156 10 false 26 5.688,2.042 6.125,2.25 0.438,0.208 10 false VAR+ 5.344,1.333 5.552,1.49 0.208,0.156 10 false 28 5.688,1.531 6.167,1.781 0.479,0.25 10 false VAL+ 5.323,2.042 5.625,2.208 0.302,0.167 10 false G1 5.313,2.552 5.615,2.719 0.302,0.167 10 false G1 5.313,3.063 5.615,3.229 0.302,0.167 10 false G1 5.313,3.573 5.615,3.74 0.302,0.167 10 false G1 5.323,1.531 5.625,1.698 0.302,0.167 10 false G1 5.344,3.375 5.552,3.531 0.208,0.156 10 false 25 1.177,4.688 1.604,4.844 0.427,0.156 10 false UDO+ 1.188,4.188 1.615,4.344 0.427,0.156 10 false UDO- 5.698,4.698 6.125,4.927 0.427,0.229 10 false US1+ 5.698,4.177 6.167,4.458 0.469,0.281 10 false US1- 5.688,3.552 6.146,3.792 0.458,0.24 10 false ADPG 5.365,4.5 5.573,4.656 0.208,0.156 10 false 3 5.365,4 5.573,4.156 0.208,0.156 10 false 2 0.625,5.708 1.771,6.188 1.146,0.479 10 false No. 1 Stereo Jack Adapter Assembly 0.625,5.531 0.948,5.719 0.323,0.188 10 false z1 5.594,5.563 6.542,6.052 0.948,0.49 10 false Radio Receiver Assembly 5.344,4.698 5.625,4.865 0.281,0.167 10 false z2 5.344,4.198 5.625,4.365 0.281,0.167 10 false z2 4.021,3.26 4.729,3.594 0.708,0.333 10 false Shielded 2.615,3.26 3.24,3.51 0.625,0.25 10 false Shielded

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER)
a.

Disconnect the G1 and z2 radio receiver assembly connectors.


b.

Disconnect the z1 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G1-28 (VAL+) - z1-6 (ALO) Always Below 1 Ω
G1-26 (VAR+) - z1-5 (ARO)
G1-27 (VA-) - z1-7 (ASGN)
G1-11 (AGND) - z1-9 (AGND)
G1-25 (ADPG) - z1-8 (AUXO)
z2-2 (US1-) - z1-2 (UDO-)
z2-3 (US1+) - z1-3 (UDO+)
G1-28 (VAL+) - Body ground Always 10 kΩ or higher
G1-26 (VAR+) - Body ground
G1-27 (VA-) - Body ground
G1-11 (AGND) - Body ground
G1-25 (ADPG) - Body ground
z2-2 (US1-) - Body ground
z2-3 (US1+) - Body ground



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR