Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › 2012.04–2012.10
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052657 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B1579  Voice Recognition Microphone Disconnected  


DESCRIPTION

Microphone signal from the telephone microphone assembly is sent to the radio and display receiver assembly.

Also, power is supplied from the radio and display receiver assembly to the telephone microphone assembly.

If microphone signal is disconnected, this DTC is stored.

This DTC is stored when a malfunction occurs in a connected device.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1579 Voice Recognition Microphone Disconnected Telephone microphone signal is lost.
·

Map light assembly (telephone microphone assembly)

·

Radio and display receiver assembly



WIRING DIAGRAM

C240174
1.354,1.844 1.531,2.021 0.177,0.177 10 false 2 1.354,1.25 1.531,1.427 0.177,0.177 10 false 3 1.354,0.635 1.531,0.813 0.177,0.177 10 false 4 5.781,3.031 5.958,3.208 0.177,0.177 10 false 6 0.813,1.927 1.292,2.135 0.479,0.208 10 false MCO- 0.813,1.344 1.313,1.594 0.5,0.25 10 false MCO+ 0.813,0.75 1.313,1.01 0.5,0.26 10 false MACC 5.99,3.104 6.552,3.344 0.563,0.24 10 false SNS2 5.708,2.438 5.885,2.615 0.177,0.177 10 false 18 2.635,2.677 3.26,2.896 0.625,0.219 10 false Shielded 3.979,2.677 4.594,2.917 0.615,0.24 10 false Shielded 5.99,2.521 6.479,2.729 0.49,0.208 10 false SGND 5.708,1.844 5.885,2.021 0.177,0.177 10 false 19 5.99,1.917 6.49,2.167 0.5,0.25 10 false MIN- 5.771,1.25 5.948,1.427 0.177,0.177 10 false 5 5.99,1.344 6.479,1.615 0.49,0.271 10 false MIN+ 5.781,0.656 5.958,0.833 0.177,0.177 10 false 4 0.302,3.583 0.594,3.74 0.292,0.156 10 false N2 0.302,3.771 2.281,4.25 1.979,0.479 10 false Map Light Assembly (Telephone Microphone Assembly) 5.719,3.604 6.292,3.76 0.573,0.156 10 false G127 5.99,0.75 6.479,1.01 0.49,0.26 10 false MACC 5.719,3.771 6.917,4.229 1.198,0.458 10 false Radio and Display Receiver Assembly

CAUTION / NOTICE / HINT

HINT:

For vehicles equipped with an Extension Module, refer to optional equipment's manuals.


PROCEDURE

1.CHECK MICROPHONE (OPERATION CHECK)

b.
E222013

When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

OK:

Check result is normal.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - MAP LIGHT)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - MAP LIGHT)
a.

Disconnect the G127 radio and display receiver assembly connector.


b.

Disconnect the N2 map light assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G127-4 (MACC) - N2-4 (MACC) Always Below 1 Ω
G127-5 (MIN+) - N2-3 (MCO+)
G127-19 (MIN-) - N2-2 (MCO-)
G127-6 (SNS2) - Body ground
G127-4 (MACC) - Body ground Always 10 kΩ or higher
G127-5 (MIN+) - Body ground
G127-19 (MIN-) - Body ground
G127-18 (SGND) - Body ground



Result:
Proceed to
OK
NG



OK

3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
a.
E199613
1.458,0.302 1.865,0.542 0.406,0.24 2.042,1.333 1.552,0.708 1.552,0.708 1.448,0.708 true 2.198,1.188 2.396,0.49 2.396,0.49 2.51,0.49 true 2.198,1.438 2.344,1.875 2.344,1.875 2.438,1.875 true 0.115,0.052 0.427,0.208 0.313,0.156 10 *a 1.5,0.344 1.906,0.563 0.406,0.219 10 G127 1.125,0.615 1.531,0.833 0.406,0.219 10 MIN- 2.552,0.417 3.083,0.698 0.531,0.281 10 MACC 2.479,1.802 3.01,2.083 0.531,0.281 10 SGND
*a Component with harness connected
(Radio and Display Receiver Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G127-18 (SGND) - Body ground Always Below 1 Ω
G127-19 (MIN-) - Body ground



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G127-4 (MACC) - Body ground Ignition switch ACC 4 to 6 V



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

4.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK
a.

Replace the telephone microphone with a normal one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>TELEPHONE MICROPHONE>REMOVAL


b.

Check if the same problem occurs again.

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)

NG

REPLACE MAP LIGHT ASSEMBLY