This circuit provides power to the radio and display receiver assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
Disconnect the G129 and G127 radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G129-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G129-4 (B) - Body ground | Always | 11 to 14 V |
| G129-3 (ACC) - Body ground | Ignition switch ACC | |
| G127-1 (IG) - Body ground | Ignition switch ON |
| Proceed to |
|---|
| OK |
| NG |
OK
NG