*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the display indicates a communication fault with the tester, inspect the DLC3.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs (Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DTC CHECK / CLEAR) and freeze frame data (Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>FREEZE FRAME DATA).
Record or print DTCs and freeze frame data, if necessary.
| Proceed to |
|---|
| NEXT |
NEXT
Clear DTCs and freeze frame data.
Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
]If the engine does not start, first perform the "Check DTC" and "Basic Inspection" procedures below.
| Result | Proceed to |
|---|---|
| Malfunction occurs | A |
| Malfunction does not occur | B |
A
B
Refer to DTC Check / Clear.
Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| Trouble code | A |
| No trouble code | B |
A
B
Conduct basic inspection.
Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>BASIC INSPECTION
| Result | Proceed to |
|---|---|
| Malfunctioning parts not confirmed | A |
| Malfunctioning parts confirmed | B |
A
B
Refer to Problem Symptoms Table.
Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>PROBLEM SYMPTOMS TABLE
Also, refer to the inspection procedure for the problem symptom.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT