DTC C1282/82 is output only in Test Mode.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1282/82 | Center Differential Lock Position Switch Malfunction (Test Mode DTC) | Detected only during Test Mode. | ·
Transfer system ·
Harness or connector ·
Skid control ECU (Brake actuator assembly) |
*C1282/82: for 4WD
The codes in this table are output only in Test Mode.
Before disconnecting the connector, make sure that there are no problems with the connection.
After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
| *a | Front view of wire harness connector
(to Skid Control ECU [Brake Actuator Assembly]) |
Set the vehicle to the 4WD state using the transfer shift lever.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A13-17 (EXI) - Body ground | ·
Ignition switch ON ·
Transfer shift position H4 |
Below 1.5 V |
Connect the skid control ECU (brake actuator assembly) connector.
Set the vehicle to the 2WD state using the transfer shift lever.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A13-17 (EXI) - Body ground | ·
Ignition switch ON ·
Transfer shift position H2 |
11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Switch the vehicle to Test Mode, perform the H2 to L4 shift operation check, and then check that DTC C1282/82 is not stored.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE
| Result | Proceed to |
|---|---|
| DTC is stored | A |
| DTC is not stored | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
w/ Differential Vacuum Actuator Assembly: Disconnect the 4WD detection switch (differential vacuum actuator assembly) connector. w/o Differential Vacuum Actuator Assembly: Disconnect the 4WD position switch (No. 3 transfer indicator switch) connector.
w/ Differential Vacuum Actuator Assembly: Disconnect the 4 wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A13-17 (EXI) - C31-3 (ADD) | Always | Below 1 Ω |
| A13-17 (EXI) - C37-8 (ADD) | Always | Below 1 Ω |
| A13-17 (EXI) - Body ground | Always | 10 kΩ or higher |
| C31-4 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A13-17 (EXI) - C28-2 | Always | Below 1 Ω |
| A13-17 (EXI) - Body ground | Always | 10 kΩ or higher |
| C28-1 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG