The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check.
Change to Test Mode (signal check) by connecting terminals TS and CG of the DLC3, and turning the ignition switch from off to ON.
Before disconnecting the connector, make sure that there are no problems with the connection.
After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G18-4 (CG) - Body ground | Always | Below 1 Ω |
| G18-12 (TS) - A13-15 (TS) | Always | Below 1 Ω |
| A13-15 (TS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG