DTC C1282 is stored only in Test Mode.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1282 | Center Differential Lock Position Switch | Stored during Test Mode. | ·
Harness or connector ·
Transfer system ·
Skid control ECU (Brake actuator assembly) |
*C1282: for 4WD
After replacing the brake actuator assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Before disconnecting the connector, make sure that there are no problems with the connection.
After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
Connect the skid control ECU (brake actuator assembly) connector.
Set the vehicle to the 4WD state using the transfer shift lever.
| *a | Front view of wire harness connector
(to Skid Control ECU [Brake Actuator Assembly]) |
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A36-20 (EXI) - Body ground | ·
Ignition switch ON ·
Transfer shift position H4 |
Below 1.5 V |
Connect the skid control ECU (brake actuator assembly) connector.
Set the vehicle to the 2WD state using the transfer shift lever.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A36-20 (EXI) - Body ground | ·
Ignition switch ON ·
Transfer shift position H2 |
11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Switch the vehicle to Test Mode, check the H2 to H4 shift operation, and then check that DTC C1282 is cleared.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE
| Tester Display |
|---|
| Signal Check |
| Result | Proceed to |
|---|---|
| Test Mode DTC is not cleared | A |
| Test Mode DTC is cleared | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Disconnect the 4WD detection switch (differential vacuum actuator assembly) connector.
Disconnect the 4 wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A36-20 (EXI) - C31-3 (ADD) | Always | Below 1 Ω |
| A36-20 (EXI) - C37-8 (ADD) | Always | Below 1 Ω |
| A36-20 (EXI) - Body ground | Always | 10 kΩ or higher |
| C31-4 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG