Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052601 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1419  Acceleration Sensor Internal Circuit  C1435  Yaw Rate Sensor Internal Circuit  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate sensor assembly via the CAN communication system.

The yaw rate sensor assembly has a built-in acceleration sensor.

If there is trouble in the bus lines between the yaw rate sensor assembly and the CAN communication system, DTCs U0123 (Lost Communication with Yaw Rate Sensor Module) and U0124 (Lost Communication with Lateral Acceleration Sensor Module) are stored.

DTC C1419 and C1435 are also stored when calibration is not completed.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1419 Acceleration Sensor Internal Circuit A data malfunction signal is received from the acceleration sensor. Acceleration sensor (Yaw rate sensor assembly)
C1435 Yaw Rate Sensor Internal Circuit A data malfunction signal is received from the yaw rate sensor. Yaw rate sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

After replacing the yaw rate sensor assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


HINT:

When DTC U0123 and/or U0124 is output together with DTC C1419 and/or C1435, inspect and repair the trouble areas indicated by DTC U0123 and/or U0124 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>U0073).


PROCEDURE

1.REPLACE YAW RATE SENSOR ASSEMBLY

Result:
Proceed to
NEXT



NEXT

END