Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2012.01–2012.04
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052601 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  TS and CG Terminal Circuit  


DESCRIPTION

Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

C167369
0.406,2.958 0.833,3.115 0.427,0.156 10 false G18 0.917,1.781 1.177,1.948 0.26,0.167 10 false CG 0.927,0.896 1.188,1.063 0.26,0.167 10 false TS 1.25,0.802 1.448,0.958 0.198,0.156 10 false 12 1.271,1.677 1.469,1.833 0.198,0.156 10 false 4 5.573,2.802 5.854,2.948 0.281,0.146 10 false A36 6.052,0.896 6.25,1.042 0.198,0.146 10 false TS 5.76,0.802 5.938,0.948 0.177,0.146 10 false 33 5.563,2.969 7.146,3.323 1.583,0.354 10 false Skid Control ECU (Brake Actuator Assembly) 0.417,3.104 0.802,3.26 0.385,0.156 10 false DLC3

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the brake actuator assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).

·

Before disconnecting the connector, make sure that there are no problems with the connection.

·

After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)
a.

Turn the ignition switch off.


b.

Disconnect the skid control ECU (brake actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A36-33 (TS) - G18-12 (TS) Always Below 1 Ω
A36-33 (TS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G18-4 (CG) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR