Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › 2012.04–2012.10
RM1840EF _58 Vehicle Interior _009641 THEFT DETERRENT / KEYLESS ENTRY _0052688 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  Engine Hood Courtesy Switch Circuit  


DESCRIPTION

The security courtesy switch is installed together with the hood lock assembly. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM

B281448
2.573,1.25 4.25,1.469 1.677,0.219 10 false Hood Lock Assembly 2.573,1.073 2.875,1.229 0.302,0.156 10 false A26 5.01,1.75 6.938,1.969 1.927,0.219 10 false Theft Warning ECU Assembly 5.01,1.583 5.333,1.75 0.323,0.167 10 false G29 5.677,0.865 6.229,1.063 0.552,0.198 10 false DSWH 5.49,0.76 5.708,0.938 0.219,0.177 10 false 9 3.844,0.76 4.042,0.927 0.198,0.167 10 false 1 2.875,0.76 3.073,0.938 0.198,0.177 10 false 2 2.573,1.427 4.26,1.854 1.688,0.427 10 false (Security Courtesy Switch)

PROCEDURE

1.INSPECT HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)
a.
B282278
0.948,0.729 1.25,0.24 1.25,0.24 1.396,0.24 false 1,0.833 1.563,0.563 1.563,0.563 1.75,0.552 false 1.448,0.156 1.76,0.313 0.313,0.156 10 false *a 1.781,0.469 2.094,0.625 0.313,0.156 10 false *b
*a Unlock position
*b Lock position


Remove the the hood lock assembly (security courtesy switch).

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Switch Condition
1 - 2 Unlock position 10 kΩ or higher
1 - 2 Lock position Below 1 Ω



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (HOOD LOCK - THEFT WARNING ECU AND BODY GROUND)

NG

REPLACE HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)

2.CHECK HARNESS AND CONNECTOR (HOOD LOCK - THEFT WARNING ECU AND BODY GROUND)
a.

Disconnect the A26 hood lock assembly (security courtesy switch) connector.


b.

Disconnect the G29 theft warning ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A26-1 - G29-9 (DSWH) Always Below 1 Ω
A26-1 or G29-9 (DSWH) - Body ground Always 10 kΩ or higher
A26-2 - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR