The security courtesy switch is installed together with the hood lock assembly. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.
| *a | Unlock position |
| *b | Lock position |
Remove the the hood lock assembly (security courtesy switch).
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Switch Condition |
|---|---|---|
| 1 - 2 | Unlock position | 10 kΩ or higher |
| 1 - 2 | Lock position | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A26 hood lock assembly (security courtesy switch) connector.
Disconnect the G29 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A26-1 - G29-9 (DSWH) | Always | Below 1 Ω |
| A26-1 or G29-9 (DSWH) - Body ground | Always | 10 kΩ or higher |
| A26-2 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>PROBLEM SYMPTOMS TABLE
NG