The No. 1 transfer indicator switch (L4 position switch) detects the gear position of the transfer shift lever.
Moving the transfer shift lever to L4 turns the L4 position switch ON. Then the ECM cancels operation of the lock-up clutch.
| *a | Front view of wire harness connector
(to No. 1 transfer indicator switch) |
Disconnect the No. 1 transfer indicator switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C29-2 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(No. 1 Transfer Indicator Switch) |
| *b | Pushed |
| *c | Not pushed |
Remove the No. 1 transfer indicator switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pushed | Below 1 Ω |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the C29 No. 1 transfer indicator switch connector.
Disconnect the C131 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C131-13 (L4) - C29-1 | Always | Below 1 Ω |
| C131-13 (L4) - Body ground | Always | 10 kΩ or higher |
| C29-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG