Home › Drivetrain › CLUTCH › CLUTCH SYSTEM › from 2012.04
RM1840EF _52 Drivetrain _009613 CLUTCH _0052509 CLUTCH SYSTEM N

CLUTCH  CLUTCH SYSTEM  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


HINT:

If any work is performed on the clutch system or if there is thought to be air in the clutch lines, bleed air from the clutch hydraulic system.


PROCEDURE

Hide 1. FILL RESERVOIR WITH BRAKE FLUID

a.

Remove the brake master cylinder reservoir filler cap assembly.


b.

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.

Brake fluid:
except TSAM Made:

SAE J1703 or FMVSS No. 116 DOT 3

for TSAM Made:

SAE J1704 or FMVSS No. 116 DOT 4



Hide 2. BLEED AIR FROM CLUTCH LINE

a.

Remove the bleeder plug cap of the release cylinder.


b.

Connect a vinyl tube to the bleeder plug.


c.

Depress the clutch pedal several times, and then loosen the bleeder plug while the pedal is depressed.


d.

When fluid no longer comes out, tighten the bleeder plug, and then release the clutch pedal.


e.

Repeat the previous 2 steps until all the air in the fluid is completely bled.


f.

Tighten the bleeder plug.

Torque:
11 N*m (110 kgf*cm, 8 ft.*lbf)


g.

Install the bleeder plug cap.


h.

Check that all the air has been bled from the clutch line.


Hide 3. CHECK FLUID LEVEL IN RESERVOIR

a.

Check for brake fluid leaks.


b.

Check the brake fluid level in the reservoir (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(w/ VSC)>ON-VEHICLE INSPECTION).


c.

Install the brake master cylinder reservoir filler cap assembly.