Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for TSAM Made) › from 2013.10
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052621 BRAKE MASTER CYLINDER(for TSAM Made) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for TSAM Made)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.

Remove the screw.


b.

Remove the brake master cylinder reservoir from the brake master cylinder sub-assembly.


Hide 2.REMOVE MASTER CYLINDER RESERVOIR GROMMET

a.

Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.


Hide 3.REMOVE BRAKE FLUID INFORMATION LABEL

Hide 4.REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

a.

Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir assembly.


Hide 5.REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER

a.

Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir assembly.


Hide 6.REMOVE BRAKE MASTER CYLINDER PISTON KIT

C236920

a.

Push in the piston and remove the snap ring using snap ring pliers.


b.
C236922

Push in the piston and remove the piston stopper bolt and gasket.


c.

Remove the No. 1 piston from the master cylinder body by pulling straight out.

NOTICE:

Do not scratch the inside of the cylinder body.



d.
C236923

Tap the flanged part against woodn blocks until the end of the No. 2 piston comes out. When the end of the No. 2 piston comes out, pull the No. 2 piston straight out of the master cylinder body.

NOTICE:

Do not scratch the inside of the cylinder body.