Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for TSAM Made) › from 2013.10
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052621 BRAKE MASTER CYLINDER(for TSAM Made) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for TSAM Made)  REMOVAL  


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

C247714
2.156,0.375 2.313,0.573 0.156,0.198 10 true A 0.979,0.583 1.135,0.781 0.156,0.198 10 false B 1.615,0.99 1.771,1.188 0.156,0.198 10 true C 2.333,1.323 2.49,1.521 0.156,0.198 10 true C 1.5,1.479 1.656,1.677 0.156,0.198 10 true C 0.708,1.24 0.865,1.438 0.156,0.198 10 false C 0.688,1.885 0.844,2.083 0.156,0.198 10 true C

a.

for Manual Transmission:

Disconnect the clutch reservoir tube labeled A from the master cylinder.


b.

Disconnect the brake fluid level warning switch connector labeled B.


c.

Using a union nut wrench, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.


d.
C247715

Remove the 2 nuts and bracket (with 3-way).


e.

Pull out the master cylinder from the brake booster.


f.

Remove the O-ring from the master cylinder.