Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052661 NAVIGATION SYSTEM Y

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the navigation system.


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
·

When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points in problem analysis:

What Vehicle model, system name
When Date, time, occurrence frequency
Where Road conditions
Under what conditions? Driving conditions, weather conditions
How did it happen? Problem symptoms


Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.



Result:
Proceed to
NEXT



NEXT

4.CHECK CABIN
4.CHECK CABIN
a.

Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

OK:

Condensation is not likely being produced and the temperature is not high or extremely low.


HINT:
·

A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

·

The navigation system may not operate normally when the temperature is -20°C (-4°F) or less, or 65°C (149°F) or higher.




Result:
Proceed to
OK
NG



OK

5.CHECK SD CARD

NG

SET CABIN TO APPROPRIATE TEMPERATURE

5.CHECK SD CARD
a.

Check that the navigation screen is displayed when the "HOME" switch is pressed.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK

Result:
Result Proceed to
The navigation screen is displayed. A
The navigation screen is not displayed, a warning message is displayed, and the navigation system continues to operate in audio mode. B
The navigation screen does not respond when the "HOME" switch is pressed. C




A

6.CHECK NAVIGATION SYSTEM NORMAL CONDITION

B

REPLACE SD CARD

C

11.PROBLEM SYMPTOMS TABLE
6.CHECK NAVIGATION SYSTEM NORMAL CONDITION
a.

Refer to Check Navigation System Normal Condition.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK


Result:
Proceed to
Symptom is not normal operation
Symptom is normal operation



Symptom is not normal operation

7.CHECK FOR DTC

Symptom is normal operation

SYMPTOM IS NORMAL OPERATION

7.CHECK FOR DTC

Result:
Proceed to
DTCs are output
DTCs are not output



DTCs are output

8.DTC CLEAR

DTCs are not output

11.PROBLEM SYMPTOMS TABLE
8.DTC CLEAR
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR

HINT:

The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.



Result:
Proceed to
NEXT



NEXT

9.RECHECK FOR DTC
9.RECHECK FOR DTC
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR

Result:
Proceed to
DTCs are output
DTCs are not output


HINT:
·

Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.

·

Check the DTCs and inspect the area that the code indicates.





DTCs are output

10.DIAGNOSTIC TROUBLE CODE CHART

DTCs are not output

11.PROBLEM SYMPTOMS TABLE
10.DIAGNOSTIC TROUBLE CODE CHART

Result:
Proceed to
NEXT



NEXT

13.CHECK CIRCUIT
11.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE

Result:
Proceed to
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table


HINT:

If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




Fault is not listed in Problem Symptoms Table

12.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

Fault is listed in Problem Symptoms Table

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

12.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

Result:
Proceed to
NEXT



NEXT

13.CHECK CIRCUIT
13.CHECK CIRCUIT
a.

Adjust, repair or replace as necessary.


Result:
Proceed to
NEXT



NEXT

14.RECHECK FOR DTC
14.RECHECK FOR DTC

Result:
Proceed to
NEXT



NEXT

15.PERFORM CONFIRMATION TEST
15.PERFORM CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END