The No. 1 stereo jack adapter assembly sends the display signal from an external device to the navigation receiver assembly via this circuit.
Disconnect the G152 navigation receiver assembly connector.
Disconnect the z8 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G152-13 (VV+) - z8-6 (VV+) | Always | Below 1 Ω |
| G152-14 (VV-) - z8-11 (VV-) | Always | Below 1 Ω |
| G152-13 (VV+) - Body ground | Always | 10 kΩ or higher |
| G152-14 (VV-) - Body ground | Always | 10 kΩ or higher |
| G152-12 (SG) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG