Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052657 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Display Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E278321
0.938,0.604 1.396,0.802 0.458,0.198 10 false VV+ 0.948,1.417 1.406,1.615 0.458,0.198 10 false VV- 0.469,2.698 0.927,2.896 0.458,0.198 10 false z8 0.479,2.865 1.625,3.219 1.146,0.354 10 false No. 1 Stereo Jack Adapter Assembly 2.313,2.406 2.875,2.615 0.563,0.208 10 false Shielded 4.177,2.406 4.74,2.615 0.563,0.208 10 false Shielded 1.354,0.531 1.917,0.74 0.563,0.208 10 false 5 1.333,1.313 1.896,1.521 0.563,0.208 10 false 10 5.656,0.521 6.219,0.729 0.563,0.208 10 false 13 5.656,1.333 6.219,1.542 0.563,0.208 10 false 14 5.646,2.115 6.208,2.323 0.563,0.208 10 false 12 5.906,0.646 6.469,0.854 0.563,0.208 10 false VV+ 5.927,1.438 6.49,1.646 0.563,0.208 10 false VV- 5.896,2.229 6.458,2.438 0.563,0.208 10 false SG 5.823,2.677 6.385,2.885 0.563,0.208 10 false G127 5.844,2.854 7.063,3.25 1.219,0.396 10 false Radio and Display Receiver Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the G127 radio and display receiver assembly connector.


b.

Disconnect the z8 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G127-13 (VV+) - z8-5 (VV+) Always Below 1 Ω
G127-14 (VV-) - z8-10 (VV-) Always Below 1 Ω
G127-13 (VV+) - Body ground Always 10 kΩ or higher
G127-14 (VV-) - Body ground Always 10 kΩ or higher
G127-12 (SG) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR