Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052657 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E278678
5.677,0.656 6.292,0.854 0.615,0.198 10 false US1- 5.667,1.167 6.281,1.365 0.615,0.198 10 false US1+ 5.448,0.531 6.063,0.729 0.615,0.198 10 false 2 5.458,1.052 6.073,1.25 0.615,0.198 10 false 3 1.219,0.646 1.833,0.844 0.615,0.198 10 false US1- 1.188,1.177 1.802,1.375 0.615,0.198 10 false US1+ 1.656,0.531 2.271,0.729 0.615,0.198 10 false 2 1.667,1.042 2.281,1.24 0.615,0.198 10 false 3 5.448,1.542 6.063,1.74 0.615,0.198 10 false z9 5.458,1.719 6.656,2.188 1.198,0.469 10 false Radio and Display Receiver Assembly 0.604,1.531 1.219,1.729 0.615,0.198 10 false z8 0.604,1.719 1.781,2.198 1.177,0.479 10 false No. 1 Stereo Jack Adapter Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the z9 radio and display receiver assembly connector.


b.

Disconnect the z8 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
z9-2 (US1-) - z8-2 (US1-) Always Below 1 Ω
z9-3 (US1+) - z8-3 (US1+) Always Below 1 Ω
z9-2 (US1-) - Body ground Always 10 kΩ or higher
z9-3 (US1+) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR