Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR › from 2014.04
RM1840EF _59 Vehicle Exterior _009653 MIRROR (EXT) _0052804 OUTER REAR VIEW MIRROR G

MIRROR (EXT)  OUTER REAR VIEW MIRROR  INSPECTION  


PROCEDURE

Hide 1.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH

a.
B263446
1.25,3.177 1.354,3.177 1.354,3.177 1.688,2.958 true 2.281,3.177 2.177,3.177 2.177,3.177 1.875,2.958 true 2.281,2.542 2.177,2.542 2.177,2.542 1.875,2.708 true 0.177,1.427 0.448,1.688 0.271,0.26 10 false *a 2.323,2.448 2.583,2.604 0.26,0.156 10 false MH 2.323,3.083 2.583,3.24 0.26,0.156 10 false MV 0.969,3.083 1.344,3.271 0.375,0.188 10 false M+
*a Component without harness connected
(Outer Rear View Mirror Assembly LH)


Disconnect the mirror connector.


b.

Apply battery voltage and check operation of the mirror.

OK:
Measurement Condition Specified Condition
Battery positive (+) →Terminal 9 (MV)
Battery negative (-) → Terminal 8 (M+)
Turns upward
Battery positive (+) → Terminal 8 (M+)
Battery negative (-) → Terminal 9 (MV)
Turns downward
Battery positive (+) → Terminal 4 (MH)
Battery negative (-) → Terminal 8 (M+)
Turns left
Battery positive (+) → Terminal 8 (M+)
Battery negative (-) → Terminal 4 (MH)
Turns right


If the result is not as specified, replace the outer rear view mirror assembly LH.


c.
B263448
1.167,4.458 1.302,4.458 1.302,4.458 1.573,4.26 true 1.167,3.833 1.302,3.833 1.302,3.833 1.573,4.021 true 0.198,2.729 0.427,3.042 0.229,0.313 10 false *a 1.646,0.042 1.813,0.219 0.167,0.177 10 false A 1.427,1.781 1.563,1.958 0.135,0.177 10 false C 2.229,2.323 2.375,2.5 0.146,0.177 10 false E 1.219,0.938 1.438,1.135 0.219,0.198 10 false B 0.875,4.375 1.115,4.521 0.24,0.146 10 false MR 0.875,3.75 1.094,3.896 0.219,0.146 10 false MF 1.792,2.115 1.927,2.313 0.135,0.198 10 false D
*a Component without harness connected
(Outer Rear View Mirror Assembly LH)


w/ Retract Mirror:

i.

For each position: Disconnect the battery, set the mirror position by hand, connect the battery, and check the retractable mirror movement.

OK:
Measurement Condition Mirror Position Specified Condition
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Forward position A Moves from A to retracted position E
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Forward position A Does not move
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Position between forward position A and driving position C Moves from B to retracted position E
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Position between forward position A and driving position C Moves from B to forward position A
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Driving position C Moves from C to retracted position E
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Driving position C Does not move
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Position between driving position C and retracted position E Moves from D to retracted position E
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Position between driving position C and retracted position E Moves from D to driving position C
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Retracted position E Does not move
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Retracted position E Moves from E to driving position C


NOTICE:
·

Disconnect and reconnect the battery between each mirror position check.

·

Do not apply battery voltage when moving the mirror by hand into each mirror position.



If the result is not as specified, replace the outer rear view mirror assembly LH.



d.

w/ Side Turn Signal Light:

i.
B276055
1.938,1.302 2.229,1.656 true 1.448,1.302 1.083,1.667 true 0.875,1.708 1.24,1.896 0.365,0.188 10 false GND 2.073,1.708 2.521,1.896 0.448,0.188 10 false TRNL 0.115,0.083 0.427,0.281 0.313,0.198 10 false *a
*a Component without harness connected
(Outer Rear View Mirror Assembly LH)


Check the side turn signal light assembly.

Apply battery voltage to the terminals of the connector, and check the illumination condition.

OK:
Tester Connection Specified Condition
Battery positive (+) → Terminal 10 (TRNL)
Battery negative (-) → Terminal 6 (GND)
Side turn signal light illuminates


If the result is not as specified, replace the side turn light assembly.



Hide 2.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH

a.
B263445
1.25,3.177 1.354,3.177 1.354,3.177 1.688,2.958 true 2.281,3.177 2.177,3.177 2.177,3.177 1.875,2.958 true 2.281,2.542 2.188,2.542 2.188,2.542 1.875,2.708 true 0.26,1.479 0.51,1.688 0.25,0.208 10 false *a 2.323,2.448 2.615,2.615 0.292,0.167 10 false MH 2.323,3.083 2.615,3.26 0.292,0.177 10 false MV 0.979,3.083 1.25,3.25 0.271,0.167 10 false M+
*a Component without harness connected
(Outer Rear View Mirror Assembly RH)


Disconnect the mirror connector.


b.

Apply battery voltage and check operation of the mirror.

OK:
Measurement Condition Specified Condition
Battery positive (+) →Terminal 9 (MV)
Battery negative (-) → Terminal 8 (M+)
Turns upward
Battery positive (+) → Terminal 8 (M+)
Battery negative (-) → Terminal 9 (MV)
Turns downward
Battery positive (+) → Terminal 4 (MH)
Battery negative (-) → Terminal 8 (M+)
Turns left
Battery positive (+) → Terminal 8 (M+)
Battery negative (-) → Terminal 4 (MH)
Turns right


If the result is not as specified, replace the outer rear view mirror assembly RH.


c.
B263447
1.146,4.417 1.281,4.417 1.281,4.417 1.563,4.229 true 1.156,3.813 1.292,3.813 1.292,3.813 1.573,3.99 true 0.229,2.656 0.542,2.865 0.313,0.208 10 false *a 1.448,0.031 1.594,0.208 0.146,0.177 10 false A 1.75,0.823 1.896,1 0.146,0.177 10 false B 1.604,1.76 1.75,1.938 0.146,0.177 10 false C 0.792,2.25 0.938,2.427 0.146,0.177 10 false E 1.219,2.063 1.365,2.24 0.146,0.177 10 false D 0.865,4.344 1.104,4.49 0.24,0.146 10 false MR 0.865,3.719 1.083,3.865 0.219,0.146 10 false MF
*a Component without harness connected
(Outer Rear View Mirror Assembly RH)


w/ Retract Mirror:

i.

For each position: Disconnect the battery, set the mirror position by hand, connect the battery, and check the retractable mirror movement.

OK:
Measurement Condition Mirror Position Specified Condition
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Forward position A Moves from A to retracted position E
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Forward position A Does not move
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Position between forward position A and driving position C Moves from B to retracted position E
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Position between forward position A and driving position C Moves from B to forward position A
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Driving position C Moves from C to retracted position E
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Driving position C Does not move
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Position between driving position C and retracted position E Moves from D to retracted position E
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Position between driving position C and retracted position E Moves from D to driving position C
Battery positive (+) → Terminal 7 (MR)
Battery negative (-) → Terminal 2 (MF)
Retracted position E Does not move
Battery negative (-) → Terminal 7 (MR)
Battery positive (+) → Terminal 2 (MF)
Retracted position E Moves from E to driving position C


NOTICE:
·

Disconnect and reconnect the battery between each mirror position check.

·

Do not apply battery voltage when moving the mirror by hand into each mirror position.



If the result is not as specified, replace the outer rear view mirror assembly RH.



d.

w/ Side Turn Signal Light:

i.
B276055
1.958,1.313 2.25,1.667 true 1.438,1.302 1.073,1.667 true 0.875,1.698 1.24,1.885 0.365,0.188 10 false GND 2.094,1.708 2.542,1.896 0.448,0.188 10 false TRNR 0.104,0.083 0.302,0.281 0.198,0.198 9 false *a
*a Component without harness connected
(Outer Rear View Mirror Assembly RH)


Check the side turn signal light assembly.

Apply battery voltage to the terminals of the connector, and check the illumination condition.

OK:
Tester Connection Specified Condition
Battery positive (+) → Terminal 10 (TRNR)
Battery negative (-) → Terminal 6 (GND)
Side turn signal light illuminates


If the result is not as specified, replace the side turn signal light assembly.