Home › Drivetrain › VF2A TRANSFER / 4WD / AWD › TRANSFER OIL › from 2014.10
RM1840EF _52 Drivetrain _009616 VF2A TRANSFER / 4WD / AWD _0052536 TRANSFER OIL A

VF2A TRANSFER / 4WD / AWD  TRANSFER OIL  REPLACEMENT  


PROCEDURE

Hide 1.DRAIN TRANSFER OIL

a.
C216678

Remove the filler plug and gasket.


b.

Remove the drain plug and gasket to drain the transfer oil.


c.

Install a new gasket to the drain plug, and then install the plug.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


Hide 2.ADD TRANSFER OIL

a.
C282090C02
2.646,0.875 2.958,1.031 0.313,0.156 10 false *a
*a 0 to 5 mm


Add transfer oil until the oil level is within 5 mm (0.196 in.) from the bottom of the transmission filler plug opening.

Transfer Oil:
for TDV Made
Transfer Oil Type Oil grade Viscosity
Toyota Genuine Transfer Gear Oil LF or Equivalent - SAE 75W

Except TDV Made
Transfer Oil Type Oil grade Viscosity
Gear Oil GL-4 or GL-5 SAE 75W-90
Toyota Genuine Transfer Gear Oil LF or Equivalent - SAE 75W


NOTICE:

Too much or too little oil will lead to transfer problems.


HINT:

Since both types of transfer oil are interchangeable, either type may be added to the transfer assembly.



b.

Install a new gasket to the filler plug, and then install the plug.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

NOTICE:
·

When adding transfer oil, make sure the vehicle is level.

·

An excessively large or small amount of oil may cause problems.

·

After adding oil, drive the vehicle and recheck the oil level.




c.

Inspect for transfer oil leaks.