COOLING SYSTEM > GENERAL



OUTLINE
  1. The cooling system is a pressurized, forced-circulation type. The reservoir tank is not pressurized.

  2. A thermostat with a bypass valve is located in the water inlet housing to maintain suitable temperature distribution in the cooling system.

  3. A water pump swirl chamber and a thermostat housing have been placed in the timing chain cover to achieve a simpler construction and a compact engine.

  4. A 3-stage temperature-controlled coupling fan, which uses the same bimetal that is used on the conventional models, controls the fan speed in 3 stages to improve cooling performance and reduce cooling fan noise.



  5. Toyota Genuine Super Long Life Coolant (SLLC) is used.


    W104265E01


    Text in Illustration 
    *1
    Thermostat
    *2
    Radiator Assembly
    *3
    Water Pump Assembly
    *4
    Water Bypass Pipe
    *a
    To Heater Core
    *b
    From Heater Core


SPECIFICATION
  1. Engine Coolant

    1. Toyota Genuine SLLC is used. The maintenance intervals are as shown in the table below:

      Engine Coolant Type
      Toyota Genuine Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids). Do not use plain water alone.
      Maintenance Intervals
      First Time
      160000 km (100000 miles)
      Subsequent
      Every 80000 km (50000 miles)
      Color
      Pink

      HINT:
      SLLC is pre-mixed (40% coolant and 60% deionized water). Therefore, no dilution is needed when SLLC in the vehicle is added or replaced.

  2. Thermostat

    Thermostat Opening Temperature
    80°C to 84°C (176°F to 183°F)