Home › ENGINE ยท 2KD-FTV › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR WITH CLUTCH PULLEY
  1. Remove the generator pulley cap.

  1. Mount the generator in a vise between aluminum plates.



    A203706E01
  1. Install SST (A) and (B) to the pulley as shown in the illustration.

    SST
    09820-63021  

    NOTICE:
    Securely attach SST to the generator pulley and generator rotor shaft.



    A203707E06
  1. Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    NOTICE:
    Be careful as the generator pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Remove SST from the generator.

  1. Remove the pulley.



2. REMOVE GENERATOR REAR END COVER


    A079302
  1. Remove the 3 nuts and generator rear end cover.



3. REMOVE TERMINAL INSULATOR


    A079342E01
  1. Remove the terminal insulator.



4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A079303
  1. Remove the 2 screws and generator brush holder assembly.



5. REMOVE GENERATOR COIL ASSEMBLY


    A079304
  1. Remove the 4 through bolts.



    A115875E03
  1. Using SST, remove the generator coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

  1. Remove the generator washer.



6. REMOVE GENERATOR ROTOR ASSEMBLY
  1. Remove the generator rotor from the drive end frame.



7. CHECK GENERATOR DRIVE END FRAME BEARING


    A079307
  1. Check that the bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.



8. REMOVE GENERATOR DRIVE END FRAME BEARING


    A079311
  1. Remove the 4 screws and bearing retainer.



    A115881E01
  1. Using SST, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)