Home › ENGINE ยท 1KD-FTV › STARTING › GLOW PLUG (w/ Glow Plug Controller)

GLOW PLUG (w/ Glow Plug Controller) > REMOVAL

for Preparation Click here


NOTICE:
  1. When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
  2. When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
  3. After removing the injection pipes, clean them with a brush and compressed air.
  4. Remove the glow plugs while they are still warm after completely warming up the engine.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY
(Click here)


4. REMOVE GLOW CONNECTOR BRACKET


A253492
  1. Disconnect the No. 1 glow plug connector and detach the clamp.



    A254198
  1. Remove the bolt and glow connector bracket.



5. REMOVE NO. 2 MANIFOLD STAY


    A245458
  1. Remove the bolt and No. 2 manifold stay.



6. REMOVE NO. 1 GLOW PLUG CONNECTOR


    A247184
  1. Remove the 4 screw grommets.



    A247185
  1. Remove the 4 nuts and No. 1 glow plug connector.



7. REMOVE NO. 1 INTAKE MANIFOLD INSULATOR


A256544


8. REMOVE GLOW PLUG


A282167
  1. Using a 12 mm deep socket wrench, remove the 4 glow plugs.