Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > No Sound can be Heard from Speakers

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
  1. Check the radio and display receiver assembly setting.

    1. Check that the volume is not set to "0".

      OK:
      The volume is not set to "0".



NG
SET VOLUME TO HIGH AND TURN MUTE OFF
OK


2.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
  1. In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

    OK:
    Audio system returns to normal.

    HINT:
    Sound quality adjustment measures vary according to the type of amplifier.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (AUDIO SETTINGS ARE DEFECTIVE)