ECD SYSTEM (for i-ART) > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Check the DTCs and freeze frame data, and then write them down.
Check the details of the DTCs (Click here).
| CLEAR DTC |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes / Clear.
Press the YES button.
| CLEAR DTC (Without using GTS) |
Perform either one of the following operations.
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI fuse from the engine room relay block and junction block assembly for more than 1 minute.