ECD SYSTEM (w/ EGR Cooler) > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE (Using Intelligent Tester) |
Check that the following conditions are met:
Battery positive voltage is 11 V or higher.
Throttle valve is fully closed.
Transmission is in neutral.
A/C is switched off.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Make sure the MIL flashes as shown in the illustration.
Start the engine.
Make sure the MIL turns off.
Simulate the conditions of the malfunction described by the customer.
Check for DTCs and freeze frame data using the tester.
After checking for DTCs, inspect the applicable circuits.