ECD SYSTEM (for i-ART) > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
Check that the following conditions are met:
Battery positive voltage is 11 V or higher.
Transmission is in neutral.
A/C is switched off.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Make sure the MIL flashes as shown in the illustration.
Start the engine.
Make sure the MIL turns off.
Simulate the conditions of the malfunction described by the customer.
Check for DTCs and freeze frame data using the GTS.
After checking for DTCs, inspect the applicable circuits.