DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0010 | An open or short in the camshaft timing oil control valve circuit (1 trip detection logic). |
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE CAMSHAFT TIMING OIL CONTROL VALVE) |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank 1).
Check the engine speed while operating the camshaft timing oil control valve using the intelligent tester.
| Tester Operation | Specified Condition |
| 0% | Normal engine speed |
| 100% | Engine idles roughly or stalls |
|
| ||||
| OK | ||
| ||
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
Inspect the camshaft timing oil control valve assembly (Click here).
![]() |
Connect the positive (+) battery terminal to terminal 1 and the negative (-) battery terminal to terminal 2. Check the valve operation.
Reinstall the camshaft timing oil control valve assembly.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY - ECM) |
Disconnect the camshaft timing oil control valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C2-2 - E21-14 (OC1+) | Always | Below 1 Ω |
| C2-1 - E21-9 (OC1-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C2-2 or E21-14 (OC1+) - Body ground | Always | 10 kΩ or higher |
| C2-1 or E21-9 (OC1-) - Body ground | Always | 10 kΩ or higher |
Reconnect the camshaft timing oil control valve assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||