DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P2118 | An open in the ETCS power source (+BM) circuit (1 trip detection logic). |
|

| 1.READ VALUE USING INTELLIGENT TESTER (+BM VOLTAGE) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / +BM Voltage.
Read the value displayed on the tester.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (+BM CIRCUIT) |
Disconnect the ECM connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E24-22 (+BM) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E23-13 (ME01) - Body ground | Always | Below 1 Ω |
| E23-5 (E1) - Body ground | Always | Below 1 Ω |
Reconnect the ECM connectors.
|
| ||||
| OK | ||
| ||