Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0630    VIN not Programmed or Mismatch - ECM / PCM

for Preparation Click here


DESCRIPTION

DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is incorrect. The VIN is input with the intelligent tester.

DTC No.
DTC Detection Condition
Trouble Area
P0630
Either condition is met (1 trip detection logic):
  1. VIN is not stored in the ECM.
  2. Input VIN is incorrect.
ECM

INSPECTION PROCEDURE

1.READ CURRENT DTC
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Read DTCs.
    Result 
    Result
    Proceed to
    P0630 is output
    A
    P0630 and other DTCs are output
    B

HINT:
If any DTCs other than P0630 are output, troubleshoot those DTCs first.

NOTICE:
If P0630 is stored, the VIN must be input to the ECM using the intelligent tester. However, all DTCs are cleared automatically by the intelligent tester when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.



B
GO TO DTC CHART (Click here)
A


2.INPUT VIN WITH INTELLIGENT TESTER
  1. Refer to Registration (Click here).


NEXT

END