LIGHTING SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / HL Auto Leveling / Data List / All Date.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Headlight Low Beam State | Low beam headlight state / ON or OFF | ON: Low beam headlights on OFF: Low beam headlights off | - |
| +B | Ignition power supply voltage value / 0 to 19.75 V | 11 to 14 V | - |
| Height Sens Pw Supply Val | Rear height control sensor power supply value / 0 to 5 V | Approximately 5.0 V | - |
| Rr Height Sens Signal Val | Rear height control sensor signal value / 0 to 5 V | Approximately 2.5 V (When vehicle level) | The value changes according to the vehicle height. |
| Vehicle Speed | Vehicle speed / 0 to 327.67 km/h | Actual vehicle speed | - |
| Rear Height Adjust Valid Flag | Result of rear vehicle height calibration / Valid or Inval | Valid: Rear vehicle height calibration completed Inval: Rear vehicle height calibration not completed | - |
| Init Writing Count | Number of times initialization performed / 0 to 255 | Current condition displayed | - |
| Sensor Initialization Hist | Sensor initialization history / not comp, 10%, 25%, 50%, 75%, 100% or complied | Current condition displayed | - |
| Number Of Trouble Codes | Number of trouble codes / 0 to 255 | Condition can be displayed | - |
| ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / HL Auto Leveling / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Drive The Leveling Motor UP | Leveling motor | ON/OFF | - |
| Drive The Leveling Motor DOWN | Leveling motor | ON/OFF | - |