Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the cruise control main switch is turned on, the CRUISE main indicator light illuminates.

WIRING DIAGRAM


E170812E06


INSPECTION PROCEDURE

1.INSPECT FUSE (MET)
  1. Disconnect the MET fuse from the driver side junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    MET fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM, BATTERY AND BODY GROUND)
E171627E02
  1. Disconnect the C10 meter connector.

  1. Disconnect the E13*1 or E5*2 ECM connector.

    1. *1: for 1GR-FE
    2. *2: for 1KD-FTV

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    C10-21 - Body ground
    Ignition switch ON
    11 to 14 V
    C10-21 - Body ground
    Ignition switch off
    Below 1 V


    Standard Resistance:
    for 1GR-FE:
    Tester Connection
    Condition
    Specified Condition
    C10-28 - E13-18 (PI)
    Always
    Below 1 Ω
    C10-28 - Body ground
    Always
    10 kΩ or higher
    C10-22 - Body ground
    Always
    Below 1 Ω
    for 1KD-FTV:
    Tester Connection
    Condition
    Specified Condition
    C10-28 - E5-3 (PI)
    Always
    Below 1 Ω
    C10-28 - Body ground
    Always
    10 kΩ or higher
    C10-22 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY