CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit |

| 1.INSPECT FUSE (MET) |
Disconnect the MET fuse from the driver side junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MET fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM, BATTERY AND BODY GROUND) |

Disconnect the C26 and C27 meter connectors.
Disconnect the E13*1, E5*2 or E31*3 ECM connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| C26-21 - Body ground | Ignition switch ON | 11 to 14 V |
| C26-21 - Body ground | Ignition switch off | Below 1 V |
| Tester Connection | Condition | Specified Condition |
| C27-8 - E13-18 (PI) | Always | Below 1 Ω |
| C27-8 - Body ground | Always | 10 kΩ or higher |
| C26-22 - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C27-8 - E5-3 (PI) | Always | Below 1 Ω |
| C27-8 - Body ground | Always | 10 kΩ or higher |
| C26-22 - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C27-8 - E31-34 (PI) | Always | Below 1 Ω |
| C27-8 - Body ground | Always | 10 kΩ or higher |
| C26-22 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||