AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
Measure the battery voltage with the ignition switch off.
| |||||
| 3.BASIC INSPECTION |
Turn the ignition switch to ON.
Check whether or not the radio receiver turns on.
| Result | Proceed to |
| Radio receiver turns on | A |
| Radio receiver does not turn on | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs.
Recheck for DTCs by simulating the operation indicated by the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|