Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE V-BANK COVER


    A112983
  1. Remove the 2 nuts and V-bank cover.



4. REMOVE NO. 2 VENTILATION HOSE


A075594


5. REMOVE AIR CLEANER ASSEMBLY


    A075595
  1. Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Remove the 2 wire harness clamps.



    A075596
  1. Loosen the 2 hose clamps.

  1. Remove the 2 bolts and air cleaner.



6. REMOVE THROTTLE BODY


    A075599
  1. Disconnect the throttle position sensor and control motor connector.

  1. Remove the 4 bolts and throttle body.

  1. Remove the gasket from the intake air surge tank.



7. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE (for Bank 1)


A111699
  1. Disconnect the oil control valve connector.

  1. Remove the bolt and oil control valve.

  1. Remove the O-ring from the oil control valve.



8. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE (for Bank 2)


A111700
  1. Disconnect the oil control valve connector.

  1. Remove the bolt and oil control valve.

  1. Remove the O-ring from the oil control valve.