ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION |
| 1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR |
![]() |
Install a new gasket to the sensor.
Install the sensor.
Connect the sensor connector.
| 2. INSTALL INTAKE MANIFOLD |
![]() |
Set a new gasket on each cylinder head.
Set the intake manifold on the cylinder heads.
![]() |
Install and uniformly tighten the 10 bolts in several passes.
Connect the 6 fuel injector connectors.
| 3. INSTALL INTAKE AIR SURGE TANK |
![]() |
Install a new gasket and the surge tank with the 2 nuts.
Using an 8 mm hexagon wrench, install the 4 bolts.
![]() |
Install the 3 upper bolts which are used to secure the 2 surge tank stays and throttle body bracket.
![]() |
Install the 3 wire harness clamps and hose clamp.
Connect the throttle position sensor and control motor connector.
Connect the purge VSV connector.
Connect the VSV (for ACIS) connector.
![]() |
Connect the No. 1 ventilation hose.
![]() |
Connect the purge line hose.
![]() |
Connect the No. 4 water by-pass hose.
![]() |
Connect the No. 5 water by-pass hose.
| 4. INSTALL THROTTLE BODY |
Install a new gasket to the intake air surge tank.
Install the throttle position sensor and control motor connector.
| 5. INSTALL AIR CLEANER ASSEMBLY |
| 6. CONNECT NO. 2 VENTILATION HOSE |
| 7. INSTALL V-BANK COVER |
| 8. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
| Item | Specified Condition |
| A/T | 9.8 liters (10.4 US qts, 8.6 Imp. qts) |
| M/T | 8.5 liters (9.0 US qts, 7.5 Imp. qts) |
Fill the radiator reservoir with TOYOTA Super Long Life Coolant (SLLC) to the F line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens.
While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,500 to 3,000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
Check the coolant level in the radiator reservoir.
If the coolant level is below the L line, add SLLC to the reservoir F line.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. CHECK FOR ENGINE COOLANT LEAKS |
Check for engine coolant leaks (Click here).
| 11. PERFORM INITIALIZATION |
Perform initialization (Click here).