Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE V-BANK COVER


    A112983
  1. Remove the 2 nuts and V-bank cover.



4. DISCONNECT NO. 2 VENTILATION HOSE


A075594


5. REMOVE AIR CLEANER ASSEMBLY


    A075595
  1. Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Remove the 2 wire harness clamps.



    A075596
  1. Loosen the 2 hose clamps.

  1. Remove the 2 bolts and air cleaner.



6. REMOVE THROTTLE BODY


    A075599
  1. Disconnect the throttle position sensor and control motor connector.

  1. Remove the 4 bolts and throttle body.

  1. Remove the gasket from the intake air surge tank.



7. REMOVE INTAKE AIR SURGE TANK


    A075597E01
  1. Disconnect the No. 5 water by-pass hose.



    A075598E01
  1. Disconnect the No. 4 water by-pass hose.



    A075644E01
  1. Disconnect the purge line hose.



    A075645E01
  1. Disconnect the No. 1 ventilation hose.



    A075646E01
  1. Disconnect the purge VSV connector.

  1. Disconnect the VSV (for ACIS) connector.

  1. Disconnect the throttle position sensor and control motor connector.

  1. Remove the 3 wire harness clamps and hose clamp.



    A075647E01
  1. Remove the 3 upper bolts, which are used to secure the 2 surge tank stays and throttle body bracket.



    A075648E01
  1. Using an 8 mm hexagon wrench, remove the 4 bolts.

  1. Remove the 2 nuts, intake air surge tank and gasket.



8. REMOVE INTAKE MANIFOLD


    A076533E01
  1. Disconnect the 6 fuel injector connectors.

  1. Remove the 10 bolts, intake manifold and 2 gaskets.



9. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


A111701
  1. Disconnect the sensor connector.

  1. Remove the sensor.

  1. Remove the gasket from the sensor.