Home › ENGINE ยท 2TR-FE › STARTING › STARTER (for 1.7 kW Type)

STARTER (for 1.7 kW Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034217E01
  1. Remove the 2 bolts and disconnect the release cylinder.



4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


C118024
  1. Remove the oil dipstick.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.



5. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



6. REMOVE STARTER ASSEMBLY


    G039103E03
  1. Disconnect the starter connector.

  1. Disconnect the terminal cap.

  1. Remove the nut and disconnect the starter wire.

  1. Remove the 2 bolts and starter.