STARTER > DISASSEMBLY |
| 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Remove the nut, and then disconnect the lead wire from terminal C.
![]() |
Using a T25 "TORX" socket wrench, remove the 3 screws holding the magnet starter switch to the starter drive housing.
Remove the magnet starter switch.
Remove the return spring.
![]() |
Remove the plunger from the pinion drive lever.
| 2. REMOVE STARTER YOKE ASSEMBLY |
![]() |
Remove the 2 bolts and starter yoke from the starter drive housing.
![]() |
Remove the cover ring and plate from the planet carrier.
| 3. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Hold the starter yoke assembly in a vise between aluminum plates.
Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.
![]() |
Remove the slotted washer.
![]() |
Remove the washer.
Remove the starter commutator end frame from the starter yoke.
![]() |
Remove the starter brush holder from the starter armature.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
![]() |
Remove the starter armature from the starter yoke.
| 5. REMOVE STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Remove the 3 planetary gears from the planet carrier.
![]() |
Remove the starter center bearing clutch, pinion drive lever and cover from the starter drive housing.
![]() |
Using a screwdriver, move the pinion stop collar toward the starter clutch.
![]() |
Using a screwdriver, remove the snap ring.
![]() |
Remove the pinion stop collar and starter clutch from the planet carrier shaft.
| 6. REMOVE PLANET CARRIER SHAFT SUB-ASSEMBLY |
![]() |
Using 2 screwdrivers and a hammer, tap off the snap ring from the planet carrier shaft.
Remove the washer from the planet carrier shaft.
![]() |
Remove the planet carrier shaft from the planet carrier.
Remove the intermediate sealing and 3 damper rubbers from the planet carrier.